User Documentation

Version 1.2 / August 2020 Page 65 / 102
How to configure the Router
The Router is set to factory default values and can be accessed using the LAN port by IP address
192.168.1.110.
1. Connect the configuration PC to Router LAN Port.
Note: Use auto-negotiation on the Ethernet Interface of the PC
2. Change the IP address of the PC to one of the range 192.168.1.0 / 24
e.g. IP address 192.168.1.99
Subnet mask 255.255.255.0
Standard gateway can be left blank due to direct cable connection
3. Start a web browser and login into the web Interface of Router (http://192.168.1.110)
User: admin
Password: Detmold
4. Set the basic IP configuration
► Select menu Configuration → IP configuration
► Configure the menu entries as following shown
Operational mode:
IP Router
IP address parameters WAN Port:
Static
192.168.20.254
255.255.255.0 (Class C)
NAT (masquerading) NOT SET
IP address parameters LAN Port:
Static
192.168.10.254
255.255.255.0 (Class C)
NAT (masquerading) NOT SET
Default gateway
Can be left blank because there exists no further
target network
► Click button “Apply settings” to activate the new settings.