User Documentation

Version 1.2 / August 2020 Page 61 / 102

Specify update from

firmware server

Update the device with a firmware from a remote HTTP/FTP/TFTP

server.

Update protocol: Protocol of the remote server which will serve the

firmware file. FTP is only supported by using anonymous user. You

can choose between HTTP, FTP and TFTP.

Server address: HTTP/FTP/TFTP server address. Valid values are

hostnames and IP addresses optionally combined with a port num-

ber i.e. 192.168.0.1:8080 or ftp.fw-server.net.

Filename and location: Filename of the firmware file including the

path on the remote server i.e. updates/firmware-1.0.0.bin

Note: There must be no leading / on HTTP

Select file for

browser update

Update the device with a firmware by using a browser file upload.

The firmware will be transmitted from the connected service PC to

the router by browse accessible folders.

Set the factory de-

faults of the new

firmware

Additionally, it can be determined whether the router should be reset

to factory default settings after the firmware update. If not set, then

the Router will use current configuration after firmware update.

4.3.3 System → Factory defaults

System → Factory default

Function

With this menu item the Router can be set to factory default settings. Please note that doing

a reset to factory values the IP addresses will be changed and the connection between the

Router and the configuration PC can be lost.

Basic factory settings:

IP address LAN port(s): 192.168.1.110

IP address WAN port (2-Port models): 192.168.2.110

IP address WAN ports (6-Port models): DHCP

User name: admin

Password: Detmold