User Documentation

Version 1.2 / August 2020 Page 59 / 102

Services → SNMP

Configuration → Services → SNMP

Function

Activation / deactivation of the SNMP protocol (Simple Network Management Protocol). Ver-

sions v1/v2/v3 are supported. Router data can be requested using Standard MIB-II.

SNMPv1/v2

Use SNMPv1 or SNMPv2 protocol specifications. This protocol ver-

sion is not encrypted and thus regarded as insecure

SNMPv3

Use the SNMPv3 protocol. You must enter additional usernames and

passwords in the fields below. SNMPv3 is regarded as secure.

SNMP read or

read/write access

You can decide whether the access with SNMP protocol should be

“read only” or read and write. For pure diagnostics, the read-only op-

tion is recommended. You can also create two different accesses.

Community name

The SNMP community name is used for authentication purposes like

a password. Most devices use the strings public (read only) and pri-

vate (read write) by default.

Community IP

Restricted access with the given community name to the following IP-

Address. Use 0.0.0.0 for any source.

Community network

mask

Network mask for the IP given above. Use 32 for a single host or 24

for a classic class C network.

User name

SNMPv3 only: Username for SNMPv3. More than 4 alphanumerical

characters are required.

Password

SNMPv3 only: Password for SNMPv3. Authentication Protocol: MD5.

More than 8 alphanumerical characters are required.

Pre-shared Key for

encryption

SNMPv3 Pre-shared key for encryption. Privacy protocol AES

Enable SNMP Trap

generation

Activate the SNMP trap generation subsystem.

SNMP Trap Com-

munity Name

SNMP trap community name for general trap identification

SNMP Trap Re-

ceiver IP

IP address of the server where the SNMP trap will be send to