User Documentation

Version 1.2 / August 2020 Page 30 / 102

4.2.1 Configuration → IP Configuration

IP Configuration → Operational mode “IP Router”

Configuration → IP configuration

Function

This is the main configuration window for setting the operating mode and the network con-

figuration (Assignment of IP data on LAN / WAN ports and optional 4G interface).

Operational mode

IP Router: Supports routing functions (Layer 3) between WAN and

LAN port(s). For 6-port models, the two WAN-Ports and the four

LAN-ports act each as unmanaged switch. The IP address ranges

of WAN and LAN side must not be the same.

LAN / WAN

IP assignment

All interfaces can be configured with static or dynamic (DHCP) IP

addresses.

Static: Assign a static IP address and subnet mask to the interface.

DHCP: Request an IP address from a DHCP (Dynamic Host Config-

uration Protocol) server.

DHCP + fallback: First, try to request an IP address by DHCP and if

it fails use the static one.

PPPoE: The IP address will be assigned by the provider.

4G (optional)

Configuration of 4G network connection

Section 4G is only available for models with 4G

interface. At factory default this interface is disa-

bled (Dial mode = disabled)

Default Gateway has to be set manually if IP ad-

dress of WAN interface will be configured stati-

cally. If WAN port is set to DHCP and checkbox

‘Gateway via DHCP’ is activated then the default

gateway is not editable.

Screenshot shows factory default operation mode

‘IP Router’.

At factory default all 2-Port Routers do have con-

figured static IP 192.168.2.110 at WAN port.

At factory default all 6-Port Routers do have con-

figured the DHCP mode for getting an IP address.

At factory default all Router variants do have con-

figured static IP 192.168.1.110 at LAN port.