User Documentation

Version 1.2 / August 2020 Page 18 / 102
3.3 Default factory settings of the Router:
Note
Some fields are linked with a hyperlink to jump directly into the corresponding menu item.
Language
English
Operation Mode
IP Router
IP address LAN Port(s)
192.168.1.110 (static value)
Subnet Mask
255.255.255.0
NAT (Masquerading) on LAN Port
Not activated
IP address WAN Port
DHCP client
Subnet Mask
255.255.255.0
NAT (Masquerading) on WAN Port
Not activated
Default gateway
No entry
DNS
Not activated
Firewall (Packet filter)
By default, data traffic in both directions between LAN and WAN is
allowed on Layer 2 and Layer 3. For that the packet filter contains
two default rules, called "Allow_L2" and "Allow_L3" (allow traffic at
Layer 2 and 3) which allows as "white lists" all network traffic.
IP routing
No static routes, Dynamic routing disabled (OSPF, RIP)
SNMP / DHCP / DNS
Disabled
VPN
Disabled
Data prioritization
Disabled
4G Modem (for 4G models only)
Disabled
3.4 Reset to factory default settings by external push button
By pressing the push button "Factory Default" the security Router can be reset at any time and regardless of
the configuration to the default settings (factory settings).
How to set the factory settings:
1. Power off the Router.
2. Press the button „Factory Default“ and keep it hold down.
3. Power on the Router and keeping button „Factory Default“ pressed while Router is booting.
4. Release button „Factory Default“ when Power LED starts flashing fast (~ 10 seconds after power on).
5. Wait until Power LED is glowing constantly green.
→ Now the Router is ready to run with factory default settings.