User Documentation

ManualsBrandsWeidmueller ManualsBattery-operated torque screwdriverDMS PRO ZERT Only for Europe

-10 -

3. 

4. During charging, the charging lamp will be lit.

When charging is completed, an internal

electronic switch will automatically be trig-

gered to prevent overcharging.

• Charging will not start if the battery pack

is warm (for example, immediately af-

ter heavy-duty operation). The orange

      

battery cools down. Charging will then

begin automatically.

5. 

the battery is approximately 80% charged.

6. When charging is completed, the



green color.

7. If the temperature of the battery pack is

0°C or less, charging takes longer to fully

charge the battery pack than the standard

charging time. Even when the battery is ful-

ly charged, it will have approximately 50%

of the power of a fully charged battery at

normal operating temperature.

8. If the power lamp does not light immediate-

ly after the charger is plugged in, or if after

the standard charging time the charging

-

sult an authorized dealer.

9. If a fully charged battery pack is inserted

into the charger again, the charging

lamp lights up. After several minutes, the



the charging is completed.

Ni-Mh Battery Pack

NOTE:

When you charge the battery pack for



charge it for about 24 hours to bring the

battery up to full capacity.

Battery charger

1. Plug the charger into the AC outlet.

NOTE:

Sparks may be produced when the plug

is inserted into the AC power supply, but

this is not a problem in terms of safety.

2. Slide the battery dock cover back to allow

insertion of the Ni-Mh battery pack.

• Verify that the cover is locked securely

in place.

3. 

4. During charging, the charging lamp will be lit.

When charging is completed, an internal

electronic switch will automatically be

triggered to prevent overcharging.

• Charging will not start if the battery pack

is warm (for example, immediately after

heavy-duty operation).

    

until the battery cools down. Charging will

then begin automatically.

5. When charging is completed, the charging



6. If the power lamp does not light immediate-