User Documentation

2583070000/00/04.201828
4 Transporting and setting up the machine
4.1 Installation location
The installation location must meet the following require-
ments:
Stable foundation with straight, even surface (for ma-
chine weight, see section 3.1).
Keep 30 cm work area free on both sides and in front of
the machine.
Electricity connection easily accessible close by.
4.2 Transporting the machine
Always wear work shoes with foot protection
when transporting the machine.
Note the weight of the machine
(see section 3.1). Use a transport aid if necessary.
To move the machine, always use the side carry han-
dles.
To prepare the machine for shipping (e.g. in the event of
servicing), use the transport packaging.
4.3 Unpacking the delivery
Check the delivery for completeness (for scope of deliv-
ery, see below).
Store away the transport packaging.
Ensure that the operating instructions are accessible to
the user at all times.
4.4 Scope of delivery
Trimming machine
Mains connection cable (10 A, 250 V)
CD with software PCCUT
PC connection cable
Operating instructions
4.5 Establishing connections
Set up the machine in the intended location.
Insert the power cable into the mains connection socket
(Figure 3.1, 13) of the machine and connect it to the
power supply.