User Documentation

2549630000/00/09.201738
7 Cleaning and maintaining the machine
7.1 Cleaning the machine externally
The machine should be freed of dust on a regular basis. It
must be cleaned externally as and when required.
Cleaning the inside is part of maintenance which
must only be carried out by trained personnel.
► Make sure that the machine is switched o󰀨.
ATTENTION
The display may become damaged
Using unsuitable cleaning agents may scratch or damage
the display.
► Clean the display carefully, either using a special
cleaning cloth for display surfaces, or with a soft cloth
and some display cleaner.
► Clean the surface of the machine with a damp cloth. If
necessary, use soap-based cleaning agents. Do not use
any abrasive cleaners or solvents.
7.2 Machine maintenance
In order to ensure fault-free operation, the following main-
tenance tasks (see section 7.3) must be performed at the
specied intervals.
WARNING
Potential risk of fatality due to electric
shock
When working on the inside of the machine,
non-insulated parts may be touched.
► Switch the machine o󰀨.
► Remove the compressed air hose from the
compressed air source.
► Pull the power plug.
► Open the front plate and place it down
carefully.
Only RS: In order to be able to access all the
areas inside the machine easily, you should
remove the waste container when starting main-
tenance work. Remember to put it back in once
work is complete.
Keep the following ready for maintenance work:
– Allen key set
– Brush and cleaning cloth
– Lubricant
– Silicone or PTFE oil
– Lubricating grease (suitable for rolling bear-
ings)