User Documentation
Setting up the machine
2549630000/00/09.201734
Adjusting the opening wedge
The opening wedge is only adjustable if the
stranded wire xing unit is in the operating posi-
tion (see section 7.6).
1
4
2
3
Figure 5.4 Opening wedge configuration (set: B)
► Release the xing screw (1) until the adjustment plate (2)
can be pressed to the left and moved backwards and
forwards.
► Bring the adjustment plate into the required position (3).
In this process, one of the catch pins (4) must t into an
opening.
► Re-apply the xing screw (1).
5.4 Performing a stripping test
Each time the material to be processed has been changed,
a stripping test must be conducted.
► Switch on the mains switch.
► Switch to "Stripping mode" operating mode on the touch
display (see section 6.5).
► Insert a wire for stripping.
► Check the result:
– Is all the stranded wire undamaged?
– Has stripping been performed straight and evenly?
► Use an uncrimped wire-end ferrule to check whether the
stripping length ts and whether the selected combina-
tion of wire and ferrule are a perfect match.
Switch to S-ferrules if required.
5.5 Setting the cutting depth
Depending on hardness and thickness, adjusting the cut-
ting depth for the stripping may be required. To do this, the
blade distance must be modied by shifting the two eccen-
trics.
► To get to both eccentrics, press the tool unit backwards
and swing it to the right.
1
2
Figure 5.5 Stripping unit
► Release both eccentrics screws (1) and (2) (2.5 mm
Allen key).
► To reduce the cutting depth, move both eccentrics to-
wards "+" (larger blade spacing).
► To increase the cutting depth, move both eccentrics to-
wards "–" (shorter blade spacing).
► Re-apply both eccentrics screws.
The conguration of both eccentrics must match
one another.