User Documentation
2549630000/00/09.201732
The machine has to be set up in the following situations:
– If a dierent type of wire-end ferrule has to be processed
– Every time the machine is put into operation
If you want to switch to another type of wire-end ferrule,
you must rst remove all of the wire-end ferrules still in the
crimping unit. To do this, please proceed as follows:
► Remove the wire-end ferrule reel.
► Continue to insert the used wire into the machine until
the wire is only stripped.
Now all wire-end ferrules are removed from the inside of
the crimping unit.
During set-up, the following settings must be checked and
adjusted if necessary:
– Wire-end ferrule role
– Ferrule cross section
– Only RS: Crimp length at four positions (s. section 5.3)
The machine must be switched o for setting up.
The adjustment table on the inner side of the front plate
shows the required settings for the various ferrule variants.
Symbol Meaning
Wire-end ferrule (type)
Use transport unit (X=yes)
B
A
C
+
+
+
-
-
-
Cable guiding unit, opening wedge, release
device
A
B
Ferrule stop
5.1 Inserting wire-end ferrules
► Set up the wire-end ferrule role (1) so that clockwise un-
rolling is ensured.
► Turn the lock (2) on the front plate (3) to open it.
The transport bolt (4) in the transport unit must be fully un-
derneath.
The transport bolt is pressed downwards by a spring.
If it is not fully down:
► Check if the transport bolt is blocked, and remove the
block if necessary.
► Push the wire-end ferrule belt into the transport unit just
until the lowest sheath latches in
► Check for rm tting by pulling the wire-end ferrule belt
carefully.
► Close the front plate using the front plate lock.
► Roll up the loose wire-end ferrule belt.
3
1
2
4
5 Setting up the machine