User Documentation

352583060000/00/03.2018
6 Operating the machine
6.1 Normal operation
► Align the machine as described in section 5.
► Before each activation, make sure that the fol-
lowing conditions are met:
– The machine has no visible damage.
– The mains connection cable is in fault-free
condition.
– The required operating pressure of 5.5 bar
is present.
– The front plate is closed.
► Switch on the mains switch.
The valves audibly start up and a reference run is execut-
ed. The selection menu is displayed on the touch display.
Figure 6.1 Touch display, display after starting
6.2 Selecting a cross section
0.50
AWG20
0.75
AWG18
1.00
AWG17
1.50
AWG16
2.50
AWG14
Ready
1783
Status:
Ready / Stripping / Crimp-
ing
Day's piece quantity:
  C E
► To select a cross section, tap on the relevant eld.
The selected cross section is displayed in inverted fashion.
You can start working now. The selection menu is dis-
played during operation. You can change the cross section
any time.
► To switch to the operating menu, press
 .
► To reset the day's piece quantity, hold down C for at
least 5 seconds.
6.3 Inserting the wire
Only process wires that are cut cleanly. All
stranded wires must nish with the insulation, no
stranded wire may be shortened or protrude.
Ensure that the end of the wire is inserted even-
ly.
40 mm
LZ:
Figure 6.2 Insert the wire correctly
► Insert a wire into the insertion funnel.
The material is drawn in slightly and processed automati-
cally. Valve noises are audible during this process.
► Once the processing is complete (no more noises), pull
the processed wire out.
6.4 Operating menus
If the operating menus are displayed on the display, only
the bottom four elds are touch-sensitive. With these you
can navigate through the program.
Figure 6.3 Touch fields in the operating menus
Button Functions

Select menu (move forwards) or increase value

Select menu (move backwards) or reduce value
C
Exitmenu(backtomenu2)
E
Activate selected menu or set value
► To select an operating menu, press the arrow keys.
► To switch to the selected menu, press E.
► Move to the desired point inside a menu using the arrow
keys.
► To activate a selected point, press E.
► To exit the menu, press C.