User Documentation

332583060000/00/03.2018
Setting up the machine
5.3 Setting the stripping length
A letter is assigned to each wire-end ferrule:
16 mm = A 14 mm = B
► Check whether the applicable letter (A or B) is set to the
following four components:
1. Ferrule stop (Figure 3.3, 4)
2. Release device (Figure 3.3, 8)
3. Stranded wire xing unit (Figure 3.3, 11)
4. Opening wedge (Figure 3.3, 1)
Conguring the ferrule stop
Figure 5.4 Ferrule stop configuration
► Swivel the tool unit to the right to reach the adjusting
wheel.
► Turn the adjusting wheel so that the required value is
underneath.
Adjusting the stripping length on the release device
Figure 5.5 Release device adjustment (set: B)
You can vary the stripping length using the setting.
► Press the adjusting wheel backwards and turn it so that
the required value is at the marked position.
► Release the adjusting wheel so that it latches in.
You can perform ne adjustments within the selected con-
guration range (A or B):
► To increase the stripping length, turn toward "+"; to re-
duce the stripping length, turn toward "–".
Conguring the stranded wire xing unit
Figure 5.6 Stranded wire fixing unit configuration (set: B)
► Pull the stranded wire xing unit (Figure 7.3, 9) forwards
and set the lever to the required value.
Adjusting the opening wedge
The opening wedge is only adjustable if the
stranded wire xing unit is in the operating posi-
tion (see section 7.6).
1
Figure 5.7 Opening wedge configuration (set: B)
► Release the xing screw (1) until the adjustment plate
can be lifted over the xing pins.
► Bring the adjustment plate into the required position.
► Re-apply the xing screw (1).