User Documentation

Setting up the machine

2518100000/03/06.201736

Adjusting the stripping length on the release device

Figure 5.4 Release device adjustment (set: B)

You can vary the stripping length using the setting.

► Press the adjusting wheel backwards and turn it so

that the required value is at the marked position (see

gure 5.4).

► Release the adjusting wheel so that it latches in.

You can perform ne adjustments within the selected con-

guration range (A, B or C):

► To increase the stripping length, turn toward "+";

to reduce the stripping length, turn toward "–".

Conguring the wire insertion unit

Figure 5.5 Wire-insertion unit configuration (set: B)

► Pull the tool unit forwards and set the lever to the re-

quired value.

Adjusting the opening wedge

The opening wedge is only adjustable if the

stranded wire xing unit is in the operating posi-

tion (see section 7.7).

Figure 5.6 Adjusting the opening wedge

► Release the xing screw (1) until the adjustment plate

can be moved and the catch pins (2) are free.

► Bring the adjustment plate into the required position (3).

In this process, one of the catch pins must t into an

opening.

► Re-apply the xing screws.