User Documentation

Setting up the machine
2516390000/03/07.201838
5.4 Insertingwire-endferrules
1. Set up the wire-end ferrule role so that clockwise unrolling
is ensured.
2. Turn the lock on the front ap to open it.
3. Swing the front ap to the side.
2.
1.
3.
Figure 5.6 Positioningthewire-endferrule
Figure 5.7 Threadingwire-endferrulesintothetransportunit
The transport bolt (gure 3.3, 2) in the transport unit must be
fully underneath. See also the sticker on the transport unit.
The transport bolt is pressed downwards by a spring.
If it is not fully down:
► Check if the transport bolt is blocked, and remove the
block if necessary.
► Push the wire-end ferrule belt into the transport unit
just until the lowest sheath latches in.
There must be no sheaths protruding downwards.
► Check for rm tting by pulling the wire-end ferrule
belt carefully.
► Close the front ap using the front ap lock.
► Roll up the loose wire-end ferrule belt.
5.5 Changingthewire-endferrulereel
► Turn the lock on the front ap to open it.
► Swing the front ap to the side.
► Press the transport bolt (gure 3.3, 2) fully upwards,
and pull the wire-end ferrule belt out of the transport
unit.
► See section 5.4.