Document of Conformity

IECEx Certificate

of Conformity

Certificate No: IECEx KEM 09.0071X Issue No: 2

Date of Issue: 2019-03-26

Schedule

EQUIPMENT:

Equipment and systems covered by this certificate are as follows:

Solenoid / Alarm driver, Type ACT20X-SDI-HDO-L-S, Type ACT20X-SDI-HDO-L-P, Type ACT20X-SDI-HDO-H-S, Type ACT20X-SDI-HDO-

H-Pand TypeACT20X-2SDI-2HDO-S, TypeACT20X-2SDI-2HDO-P for rail mounting are 24 V powered isolating barriers, converting digital

signals from PLC's and other equipment into signals for driving valves, solenoids and light emitting diodes located in a hazardous area.

Ambient temperature range -20 °C to +60 °C.

For electrical data, refer to the Annex to this certificate.

SPECIFIC CONDITIONS OF USE: YES as shown below:

The Solenoid / Alarm driver shall be installed in a controlled environment with suitable reduced pollution, limited to pollution degree 2 or

better.

The non-intrinsically safe circuits may only be connected to an overvoltage category I or II power source, as defined in IEC 60664-1.

If the Solenoid / Alarm driver is installed in an explosive atmosphere where the use of equipment protection level Gc is required, the Solenoid

/ Alarm driver shall be installed in an enclosure in type of protection Ex n or Ex e, providing a degree of protection of at least IP54.

Cable entry devices and blanking elements shall fulfil the same requirement.

Page 3 of