Document of Conformity

[13] Schedule

[14] TYPE EXAMINATION CERTIFICATE No.

DEMKO 18 ATEX 2097X Rev. 1

00-IC-F0060-1 – Issue 15.1 This certificate may only be reproduced in its entirety and without any change, schedule included. Page 2 of 2

[15] Description of Product:

This device is an Analog temperature monitor, which contains two relay outputs, and a PTC sensor or PT100 input terminal blocks. When

the PT100 or PTC sensor's input temperature is over-temperature or under-temperature, the relay output changes. These units do not have

a complete electrical enclosure and must be placed into a separate enclosure in the final installation.

Nomenclature for type ACT20P-TMR-RTI-S and ACT20P-TMR-RTI-P:

ACT20P

TMR

RTI

1: Product series

- ACT20P

2: Product Function: Temperature Monitor and Relay output

- TMR

3: Input signal type: Pt100 sensor or PTC sensor

- RTI

4: Connection type: Screw or Push-In

- S: Screw connection

- P: Push-In connection

The optical radiation output of the product with respect to explosion protection, according to Annex II clause 1.3.1 of the Directive

2014/34/EU is covered in this certificate based on Exception 1 to the scope of EN 60079-28:2015.

Temperature range:

The ambient temperature range is -25 C ≤ Tamb ≤ +65C

Electrical data

Power input: 24~240 V ac/ V dc, 40~60Hz, Max. 2.2 W

Signal input: PT100/PTC sensor

Relay Output: 250 V ac, 5 A

Routine tests:

A dielectric strength routine test is required in accordance with EN 60079-15, clause 6.2. Alternatively, test shall be carried out at 1.2 times

the test voltage, but shall be maintained for at least 100ms.

[16] Descriptive Documents

The scheduled drawings are listed in the report no. provided under item no. [ 8 ] on page 1 of this Type Examination Certificate.

[17] Special Conditions of Use:

The equipment shall be installed in an enclosure that provides a degree of protection not less than IP 54 in accordance with EN 60079-0.

[18] Essential Health and Safety Requirements

The Essential Health and Safety Requirements (EHSRs) covered by the standards listed at item 9.

Additional information

The trademark will be used as the company identifier on the marking label.