User manual
5 Detailed descriptions of the eldbus coupler | DeviceNet eldbus coupler UR20-FBC-DN
94 1432790000/08/12.2015Manual u-remote
Object descriptions UR20-FBC-DN: CIP Common classes
Class Attribute Get Set NV
1)
Data type
2)
Name Description
hex dez
DeviceNet 0x03 (3)
Instanz 0x00 (0)
0x01 1 x UINT Revision Revision of this object
Instanz 0x01 (1)
4)
0x01 1 x x x USINT MAC ID Network address of the device
0x02 2 x x x USINT Baudrate Baud rate of the device
0x03 3 x x x USINT Bus-Off Interrupt
With “0” a communication fault will be sent on
Bus-Off-Interrupt (s. LED). With “1” a reset of the
CAN driver will be run.
0x04 4 x x USINT Bus-Off counter Counter for Bus-Off-Interrupts
0x05 5 x Struct{Byte,USINT} Allocation Information
Allocation Information. (Byte = Predened Master/
Slave Connection Set. Attribute is neede, if the Pre-
dened Master/Slave Connection Set is supported.
USINT = MAC ID)
0x06 6 x BOOL
MAC ID Switch
Changed
Rotary switch for the MAC-ID has been changed
0x07 7 x BOOL Baudrate Switch Changed The baud rate has been changed via the web server
0x08 8 x USINT MAC ID Switch Value MAC-ID value set by the rotary switches
0x09 9 x USINT Baudrate Switch Value Value of the baud rate switch in the web server
Assembly 0x04 (4)
Instance 0x00 (0)
0x01 1 x UINT Revision Revision of this object
0x03 3 x UINT Number of Instances Current number of Instances
Instanceen 0x65 ... 0x68 (101 ... 104)
0x03 3 x x Array of BYTE Data Process data
0x04 4 x UINT Size Size of process data
Connection Class 0x05 (5)
Instance 0x00 (0)
5)
0x01 1 x UINT Revision Revision of this object
Instance 0x01 (1)
3)
6)
0x01 1 x USINT State Status of this object
0x02 2 x USINT Instance type I/O or messaging connection
0x03 3 x BYTE Transportclass trigger Behaviour of the connection
0x04 4 x UINT Produced connection ID
Value in the CAN identier eld for a message sent
by the device
0x05 5 x UINT Consumed connection ID
Value in the CAN identier eld for a message
received by the device
1) Non volatile (data are saved permanently); 2) For the description of data types refer to table Data types; 3) Reset; 4) Alloc Group2 idset; Release group2 id set;
5)Create; 6) Delete