User manual
▶ Lift the electronic unit removal lever and swivel it for-
wards by 90°.
1.
2.
Unlocking the electronic unit
Opening the removal lever for the electronic unit
▶ Using the removal lever, pull the electronic unit forwards
and out.
Pulling out the electronic unit
▶ If the existing electronic unit was coded, insert the new
coding pins into the coding seats located in the base
module (see Section 7.4).
▶ Safe I/O modules: Make sure, that the same address is
set on the new electronic unit like on the old one (DIP-
switches).
11 Replacingcomponents | Replacing the electronic unit
463Manual u-remote1432790000/08/12.2015