User manual
10.8 Displaying module data and editing
parameters
These functions are only accessible when
Force mode is not activated.
Parameters can only be written when the eld
bus is not active.
▶ Click on a module if you would like to see its properties.
A window with all status values opens.
Module Status dialogue box
▶ To open the datasheet for the module, click on the link
next to Name.
▶ To change individual parameters, click Parameters.
All the parameters are then listed in a new window.
Editing module parameters
For parameters which can be edited, alternative settings are
offered in a dropdown menu.
▶ Select the parameter you would like to change.
▶ Select the desired setting from the dropdown menu.
▶ To save the change, click Apply. You can now change
other parameters.
▶ To save all changes and close the window, click OK.
▶ Click on Close to close the Module Status window.
Modules with registers
For modules with registers (e.g. counter modules and PWM
modules), the register settings are displayed in a tool tip.
▶ Move the cursor over the Status entry to see the register
settings.
The registers displayed in bold are activated, all of the others
are deactivated.
Displaying register settings
10 Webserver| Displaying module data and editing parameters
454 1432790000/08/12.2015Manual u-remote