User manual
Searching for Ethernet participants
▶ Enter the MAC address of the participant or click on
Browse to look for all connected participants.
The connected participants are displayed.
Ethernet participants found on the network
▶ To identify a participant at the station, click on Flash.
The data-transfer LED on the identied device now ashes.
▶ To stop the flashing, click on Stop flashing.
▶ Navigate to the list of participants and click on the one
you would like to edit.
Editing Ethernet participants
▶ Change the IP address and subnet mask as required
and click on Assign IP configuration.
▶ To change the device name, enter the new name and
click on Assign name.
▶ If you would like to change the properties of other partici-
pants, click once again on Browse and select the next
participant.
▶ Make the changes as described above.
▶ When you have finished editing all of the participants,
click on Close.
These settings are sent directly to the devices!
9 Commissioning| Commissioning the UR20-FBC-PN-IRT
446 1432790000/08/12.2015Manual u-remote