User manual

6 Detailed descriptions of I/O modules | Digital counter module UR20-2CNT-100
361Manual u-remote1432790000/08/12.2015
24V
>1
=
>1
=
=
=
parameter CH1
CH0 ACH1 ACH1 B CH0 B
Filter *
Parameter: load value CH2 integer 32
Reset: flags overrun, underrun, comparison, end value, CCTRL I bit 6
Reset: flags overrun, underrun, comparison, end value, CCTRL II bit 6
Parameter:
load value CH1 integer 32
UR20-2CNT-100 Counter operation through parameter\signal evaluation\ pulse/direction (A/B)
Filter *
SW gate set CCTRL II bit 2
SW gate reset CCTRL II bit 10
SW gate set CCTRL I bit 2
SW gate reset CCTRL I bit 10
Parameter: cancel/interrupt internal gate 0 counter function
Parameter: end value CH1 integer 32
CCTRL II
Parameter: end value CH0 integer 32
bit 1 set bit 9 reset
CCTRL I
bit 1 set bit 9 reset
I/O image setting value CH1 integer 32
Load setting value CCTRL II bit 5
Counting value 1/2
I/O image setting value CH0 integer 32
Load setting value CCTRL I bit 5
Status word 1/2 Time stamp Alarm for diagnostic messages
Bus
Set comparison bit
Counter Counter
Set comparison bit
parameter CH0
Alarms
* see overview of the editable parameter
Parameter: - comparison value ≤ - comparison value ≥ - comparison value =
Parameter: - comparison value ≤ - comparison value ≥ - comparison value =
Parameter:
cancel/interrupt internal gate 1 counter function
Parameter: counter function CH0 continuous = open
Parameter: counter function CH1 continuous = open