User manual

6 Detailed descriptions of I/O modules | Digital counter module UR20-2CNT-100
360 1432790000/08/12.2015Manual u-remote
24 V
==
≥ 1 ≥ 1
Counter 1
CH0 ACH1 ACH1 B CH0 B
Parameter: cancel/interrupt internal gate 0 counter function
I/O image setting value CH1 integer 32
Parameter: counter function CH0 continuous = open
Parameter:
load value CH1 integer 32
Parameter:
load value CH0 integer 32
Bit 1 set Bit 9 reset
SW gate set CCTRL II bit 2
CCTRL II
CCTRL I
bit 1 set bit 9 reset
SW gate reset
SW gate set CCTRL I bit 2
CCTRL II bit 10
Load setting value CCTRL II bit 5
Reset: flags overrun, underrun, comparison, end value, CCTRL II bit 6
SW gate reset CCTRL I bit 10
Alarms
I/O image
setting value CH0
integer 32
Parameter: end value CH0 integer 32
Load setting value CCTRL I bit 5
Reset: flags overrun, underrun, comparison, end value, CCTRL I bit 6
Filter *Filter *Filter *Filter *
Counting value 1/2 Status word 1/2 Time stamp Alarm for diagnostic messages
Bus
Set comparison bit parameter CH1
Set comparison bit parameter CH0
UR20-2CNT-100 Counter operation through parameter\signal evaluation\rotary transducer xxx
Parameter:
cancel/interrupt internal gate 1 counter function
Counter 0
* see overview of the editable parameter
Parameter: - comparison value ≤ - comparison value ≥ - comparison value =
Parameter: - comparison value ≤ - comparison value ≥ - comparison value =
Parameter: end value CH1 integer 32
Parameter: counter function CH1 continuous = open