User manual

6 Detailed descriptions of I/O modules | Digital counter module UR20-1CNT-100-1DO
347Manual u-remote1432790000/08/12.2015
1 0
&
=
=
24 V
≥
Filter *
Parameter: counting direction Inverted / non-inverted
UR20-1CNT-100-1DO Counter operation through parameter\signal evaluation\pulse/direction (A/B)
Filter *Filter *Filter *Filter *
CH0 ACH0 BOutResetLatchGate
Counting value Latch Status word Time stamp Alarm for diagnostic messages
Parameter:
counter function continuous = open
Parameter:
end value integer 32
I/O image: setting value integer 32
Parameter: cancel/interrupt internal gate counter function
I/O image: Comparison value integer 32
Bus
Counter
Latch
Alarms
Parameter pulse duration
CCTRL I Bit 1 activated = active
Parameter: HW gate 0 active / 1 open with 24 V
Parameter: load value integer 32
* see overview of the editable parameter
SW gate set CCTRL I Bit 2
CCTRL I CTRL Sync Set Bit 0
Parameter:
reset - disabled - high level - rising edge - 1-time rising edge
Parameter: output function - never - comparison value ≤ - comparison value ≥ - comparison value =
Load setting value CCTRL I Bit 5