User manual

6 Detailed descriptions of I/O modules | Digital counter module UR20-1CNT-100-1DO
346 1432790000/08/12.2015Manual u-remote
=
&
=
24 V
≥
UR20-1CNT-100-1DO Counter operation through parameter\signal evaluation\rotary transducer xxx
Parameter pulse duration
Bus
CH0 ACH0 BOutResetLatchGate
Parameter: cancel/interrupt internal gate counter function
I/O image setting value integer 32
Parameter: end value integer 32
Parameter: counter function continuous = open
Parameter: load value integer 32
Load setting value CCTRL I Bit 5
Parameter: HW gate 0 active / 1 open with 24 V
Parameter:
reset - disabled - high level - rising edge - 1-time rising edge
Counter
Latch
Alarms
Counting value Latch Status word Time stamp Alarm for diagnostic messages
Filter *Filter *Filter *Filter *
Filter *
Parameter: output function - never - comparison value ≤ - comparison value ≥ - comparison value =
I/O image: comparison value Integer 32
CCTRL I CTRL Sync Set Bit 0
SW gate set CCTRL I Bit 2
CCTRL I Bit 1 activated = active
* see overview of the editable parameter