User's Manual

BEFORE YOU BEGIN

Thank you for selecting the WEIDER

resistance sys-

tem POWER

PAK. The POWER PAK is designed to

increase the amount of resistance available on the

PLA

TINUM PLUS BY WEIDER resistance system.

For your benefit, read this manual carefully before

using the POWER PAK and the resistance system.

If you have questions after reading this manual, please

call our Customer Service Department toll-free at

1-877-992-5999, Monday through Friday

, 6 a.m. until

6 p.m. Mountain Time (excluding holidays). To help us

assist you, please note the product model number and

serial number before calling. The model number is

WEMC06740.

The serial number can be found on the

product packaging. Record the serial number on the

front cover of this manual.

1. Remove the Side Mech Cover (A) from the Mech

Covers (B, C).

2. See drawing A. Remove the Cover Plate (D)

from the Side Mech Cover (A).

See drawing B. Snap the Sensor Plate (11) into

the Side Mech Cover (A).

3. Locate the Sensor Wire (E) (see the inset draw-

ing). Connect the Sensor Wire to the Sensor

Plate (11).

Replace the Side Mech Cover (A) onto the Mech

Covers (B, C) (see drawing 1).

5. Make sure that all parts are properly secured.

The use of the remaining parts will be

explained in the

ADJUSTMENT section.

2 A B

ASSEMBLY