User's Manual

BEFORE YOU BEGIN

Thank you for selecting the WEIDER

resistance sys-

em MAX PACK accessories. The MAX PACK is

designed to increase the amount of resistance avail-

ble on the PLATINUM PLUS BY WEIDER resistance

system.

For your benefit, read this manual carefully before

using the MAX PACK and the resistance system. If

you have questions after reading this manual, see the

ront cover of this manual. To help us assist you,

please note the product model number and serial

umber before calling. The model number is

WEMC0674.0. The serial number can be found on the

roduct packaging. Record the serial number on the

front cover of this manual.

1. Remove the Side Mech Cover (A) from the Mech

Covers (B, C).

2. Remove the Cover Plate (D) from the Side Mech

Cover (A).

3. Locate the Sensor Wire (E) (see the inset draw-

ing). Connect the Sensor Wire to the Sensor

Plate (11). The connector should slide easily

into the socket and snap into place.

If the con-

nector does not slide easily and snap into place,

turn the connector over and then insert it. IF THE

CONNECTOR IS NOT INSERTED PROPERLY,

THE CONSOLE MAY BE DAMAGED WHEN

THE POWER IS TURNED ON.

Snap the Sensor Plate (1

1) into the Side Mech

Cover (A).

4. Replace the Side Mech Cover (A) onto the Mech

Covers (B, C) (see drawing 1).

Make sure that all parts are properly secured.

The use of the remaining parts will be

explained in the

ADJUSTMENT section.

ASSEMBLY