User`s manual

ManualsBrandsWeider ManualsHome GymWEEVSY87210

BEFORE YOU BEGIN

ASSEMBLED

DIMENSIONS:

Height:

188 cm (74 in.)

Width:

102 cm (40 in.)

Length:

135 cm (53 in.)

Foot Plate

Low Pulley Station

High Pulley Station

Lat Bar

Seat

Leg Lever

Butterfly Arms

Press Arm

Weight Stack

Weight Pin

Backrest

Stepper Pedals

Resistance Cylinders

Thank you for selecting the versatile WEIDER

8515

weight system. The WEIDER 8515 weight system

offers a selection of weight stations designed to devel-

op every major muscle group of the body. Whether

your goal is to tone your body, build dramatic muscle

size and strength, or improve your cardiovascular sys-

tem, the WEIDER 8515 weight system will help you to

achieve the specific results you want.

For your benefit, read this manual carefully before

using the weight system. If you have additional

questions, please call our Customer Service Depart-

ment at 08457 089 009. To help us assist you, please

note the product model number and serial number

before calling. The model number is WEEVSY87210.

The serial number can be found on a decal on the

weight system (see the front cover of this manual).

Before reading further, please review the drawing

below and familiarise yourself with the parts that are

labelled.

TROUBLESHOOTING AND MAINTENANCE

Inspect and tighten all parts often and replace any worn parts immediately. The weight system can be cleaned

using a damp cloth and mild non-abrasive detergent. Do not use solvents.

TIGHTENING THE CABLES

Woven cable, the type of cable used on the weight

system, can stretch slightly when it is first used. If

there is slack in the cables before resistance is felt,

the cables should be tightened. IMPORTANT: The

Weight Pin (26) must be inserted under the middle

Weight (25) before the cables can be tightened.

Slack can be removed from the cables three different

ways:

• See drawing 1. Tighten the 1/4” Nylon Locknut (2)

at the end of the Long Cable (23). To do this you

may need to remove the Small “U” -Bracket (67)

from the Weight Tube (63). Make sure that the

cables are not too tight, or the Top Weight (76)

will be lifted off the weight stack.

• See drawing 2. Tighten the 1/4” Nylon Locknut (2)

at the end of the Short Cable (58). To do this you

may need to remove the 3 1/2” Pulley (15) and

the Pulley Covers (89) from the Long “U”-Bracket

(57). Make sure that the cables are not too tight,

or the Top Weight (76) will be lifted off the weight

stack.

• See drawing 2. Move the 3 1/2” Pulley (15) and

the Pulley Covers (89) to the other hole in the

Long “U”-Bracket (57). Remove the 3/8” Nylon

Locknut (21) and the 3/8” x 2” Bolt (12) from the

Pulley, and the Long “U”-Bracket. Re-attach the

Pulley and Pulley Covers. Be sure that the Cable

and Pulley move smoothly.

Note: Inspect all cables before each use. If a cable tends to slip off the pulleys often, the cable may have

become twisted. Remove the cable and re-install it.

If the cables need to be replaced, see ORDERING REPLACEMENT PARTS on the back cover of this manual.

Replace all cables every two years.