User's Manual

22
47. Press two 3/4” Round Inner Caps (34) into
each Pad Tube (28).
Insert a Pad Tube (28) into the Front Seat
Frame (36). Slide a Foam Pad (30) onto each
end of the Pad Tube.
Insert the other Pad Tube (28) into the Leg
Lever (29). Slide a Foam Foam Pad (30) onto
each end of the Pad Tube.
48. Align the welded tubes on the Leg Press
Plate (95) with one set of holes in the Leg
Press Arm (96). Attach the Leg Press Plate to
the Leg Press Arm with the Press Pin (97).
Press a 2” Square Inner Cap (27) into the Leg
Press Arm (96).
49. Remove the backing from the PRO 9645
decal and apply it to the home gym system
where shown.
Make sure that all parts have been properly
tightened. The use of the remaining parts will
be explained in HOW TO USE THE HOME
GYM SYSTEM, beginning on page 23 of this
manual.
Before using the home gym system, pull each
cable a few times to be sure that the cables
move smoothly over the pulleys. If one of the
cables does not move smoothly, find and cor-
rect the problem. IMPORTANT: If the cables
are not properly installed, they may be
damaged when heavy weight is used. See
the CABLE DIAGRAMS on page 27 of this
manual for proper cable routing. If there is
any slack in the cables, you will need to
remove it by tightening the cables. See
TROUBLE-SHOOTING AND MAINTE-
NANCE on page 26.
47
SEAT ASSEMBLY
DECAL
30
30
29
95
27
97
96
34
36
34
28
PRO 9645
Decal
48
Welded Tube