User's Manual

14
24. See the inset drawing. Wrap the High Cable
(58) around a 3 1/2” Pulley (15). Attach the
Pulley and a set of Pulley Covers (114) to the
upper hole in a Long “U”-Bracket (57) with a
3/8” x 2” Bolt (12) and a 3/8” Nylon Locknut
(21). Note: This may be pre-assembled. Be
sure that the small tabs on the Pulley
Covers are in the position shown and that
the Cable and Pulley move smoothly.
25. Wrap the High Cable (58) around a 3 1/2”
Pulley (15). Attach the Pulley to the bracket on
the Top Frame (55) with a 3/8” x 2” Bolt (12)
and a 3/8” Nylon Locknut (21). Be sure that
the Cable is in the groove of the Pulley and
that the Cable and Pulley move smoothly.
26. Slide a 3/8” Flat Washer (9) onto a 3/8” x 3
3/4” Bolt (88). Insert the Bolt through the lower
hole in the Press Frame (17). Attach the 5/8” x
9/16” Spacer (7) and the 3 1/2” Low Pulley
(102) to the Bolt with a 3/8” Nylon Locknut
(21). Do not tighten the Nylon Locknut yet.
Be sure that the Bolt, the Flat Washer, the
Spacer, the Low Pulley, and the Nylon
Locknut are oriented as shown.
24
58
15
114
114
114
21
12
57
Bracket
55
21
12
15
58
25
26
CABLE ASSEMBLY
58
Small tabs
should be up.
57
21
17
102
7
9
88