User's Manual

11
22
80
Rod
28
71
76
11
20. Attach a Pulley Housing (94) to the indicated “U”-
channel on the 5 kg (10 lbs.) centre Crossbow
(44) with an M10 x 102mm Bolt (24), two Pivot
Bushings (74), and an M10 Nylon Locknut (76).
Wrap the Long Cable (80) around a 90mm Pulley
(28). Attach the Pulley and a pair of Pulley
Covers (29) inside of the Pulley Housing (94) with
an M10 x 47mm Button Head Bolt (71) and an
M10 Nylon Locknut (76).
Make sure the small
tabs on the Pulley Covers are in the indicated
position.
21. Wrap the Long Cable (80) around a 90mm Pulley
(28). Attach the Pulley and a pair of Pulley
Covers (29) to the indicated M10 x 143mm
Carriage Bolt (73) with an M10 Nylon Locknut
(76).
Make sure the small tabs on the Pulley
Covers are in the indicated position.
19. Wrap the Long Cable (80) under a 90mm Pulley
(28) as shown. Attach the Pulley and a pair of
Pulley Covers (29) to the Upright (3) with an M10
x 116mm Button Head Bolt (40) and an M10
Nylon Locknut (76).
Make sure the small tabs
on the Pulley Covers are in the indicated posi-
tion.
19
20
21
80
29
29
40
28
3
76
28
29
29
74
94
74
76
80
71
28
80
29
29
76
73
24
44
Small
Tab
Small
Tab
Small
Tab
22
109
22. Make sure there are no Crossbows (not shown)
under the “U”-channels on the 5 kg (10 lbs.) cen-
tre Crossbow (not shown). Have a second person
pull on the Long Cable (80) to create slack in the
Cable.
Insert the end of the Long Cable (80) through the
welded tube on the Cross Tube (11). If necessary,
use the tip of a screwdriver to pull the end of the
Cable out of the Swivel Arm (22).
Make sure the
Cable is on the indicated side of the welded
rod in the Swivel Arm.
Wrap the Long Cable (80) around a 90mm Pulley
(28). Attach the Pulley and the Half Pulley Cover
(109) inside of the Swivel Arm (22) with an M10 x
47mm Button Head Bolt (71) and an M10 Nylon
Locknut (76).