User`s manual

ManualsBrandsWeider ManualsHome GymWEEVSY52000

SEAT ASSEMBLYMISC.

8. Lubricate the insides of the holes in the Top

Weights (24) as shown. Slide a Top Weight

onto each set of Weight Guides (23).

9. Attach the Top Frame (2) to the Ab Upright (1)

with two 5/16” x 2 3/4” Bolts (55), two 5/16”

Washers (20), and two 5/16” Nylon Locknuts

(40). Do not tighten the Nylon Locknuts

yet.

Attach the Butterfly Frame (3) to the Leg

Press Upright (4) with two 5/16” x 2 3/4” Bolts

(55), two 5/16” Washers (20), and two 5/16”

Nylon Locknuts (40). Do not tighten the

Nylon Locknuts yet.

10. Attach the upper ends of one set of Weight

Guides (23) to the Top Frame (2) with a 5/16”

x 6” Bolt (67), two 1/2” x 3/4” Spacers (69),

and a 5/16” Nylon Locknut (40).

Attach the upper ends of the other set of

Weight Guides (23) in the same manner.

Before continuing, firmly tighten all nylon

locknuts used in steps 1 through 10.

59. Make sure that all parts have been properly tightened. The use of the remaining parts will be explained

in HOW TO USE THE TRAINING SYSTEM, beginning on page 22 of this manual.

Before using the training system, pull each cable a few times to be sure that the cables move smoothly

over the pulleys. If one of the cables does not move smoothly, find and correct the problem. IMPOR-

TANT: If the cables are not properly installed, they may be damaged when heavy weight is

used. See the CABLE DIAGRAMS on pages 26 and 27 of this manual for proper cable routing. If

there is any slack in the cables, you will need to remove the slack by tightening the cables. See

TROUBLE-SHOOTING AND MAINTENANCE on page 25.

FRAME ASSEMBLY

56. Press two 3/4” Round Inner Caps (78) into

each Pad Tube (28).

Insert a Pad Tube (28) into the Rear Seat

Frame (16). Slide a Foam Pad (29) onto each

end of the Pad Tube.

Insert the other Pad Tube (28) into the Leg

Lever (15). Slide a Foam Pad (29) onto each

end of the Pad Tube.

57. Attach the Large Backrest (19) to the Leg Press

Upright (4) with two 1/4” x 2 1/2” Machine

Screws (64) and two 1/4” Washers (37).

58. Insert a 1/4” x 2 1/2” Carriage Bolt (60)

through the centre hole in a Seat Plate (41).

Attach the Seat Plate to a Seat (17) with two

1/4” x 3/4” Screws (59).

Insert the 1/4” x 2 1/2” Carriage Bolt (60)

through the indicated hole in the Front Seat

Frame (8). Tighten a 1/4” Nylon Locknut (44)

with a 1/4” Washer (37) onto the Carriage Bolt.

Attach the other end of the Seat (17) to the

Front Seat Frame (8) with a 1/4” Washer (37)

and a 1/4” x 2 1/2” Machine Screw (64).

Lubricate