User`s manual

15
32. Route the Press Cable (88) around a 3 1/2”
Pulley (82). Attache the Pulley and a set of
Pulley Covers (94) to the lowest set of holes
in the Pulley Plates (31) with a 3/8” x 2” Bolt
(50) and a 3/8” Nylon Locknut (42). The
Cable must be routed from the direction
shown. Be sure that the small tabs on the
Pulley Covers are facing down.
Tighten the 3/8” x 2” Bolt (50) and the 3/8”
Nylon Locknut (42).
33. Route the Press Cable (88) around a 3 1/2”
Pulley (82). Attach the Pulley and a set of
Pulley Covers (94) to the Leg Press Upright
(4) with a 3/8” x 3 3/4” Bolt (76), two 3/8”
Washers (38) and a 3/8” Nylon Jam Nut (43).
The Cable must be routed from the direc-
tion shown. Be sure that the small tabs on
the Pulley Covers are facing up.
34. Route the Press Cable (88) over the indicated
3 1/2” Pulley (82) attached to the Press
Frame (12). Tighten the 3/8” x 3 1/2” Bolt (66)
and the 3/8” Nylon Locknut (not shown).
35. Wrap the Press Cable (88) around a V-Pulley
(98). Attach the V-Pulley to the upper bracket
on the Leg Press Upright (4) with a 3/8” x 2
1/4” Bolt (83) and a 3/8” Nylon Jam Nut (43).
33
34
35
CABLE ASSEMBLY
14
29. Identify the Press Cable (88)—this is the
longest Cable. Attach the end of the Press
Cable to the Large “U” Bracket (84) with a
1/4” Nylon Locknut (44) and a 1/4” Washer
(37). Do not completely tighten the Nylon
Locknut. It should be threaded onto the
end of the Cable so only a couple of
threads are showing above the Nylon
Locknut, as shown in the inset drawing.
30. Wrap the Press Cable (88) around a 3 1/2”
Pulley (82). Attach the Pulley and a Cable
Trap (80) to the indicated bracket on the
Press Base (13) with a 3/8” x 2” Bolt (50) and
a 3/8” Nylon Locknut (42). Be sure that the
Cable Trap is turned to hold the Cable in
place.
31. Wrap the Press Cable (88) around a 3 1/2”
Pulley (82). Attach the Pulley and a Cable
Trap (80) to the other bracket on the Press
Base (13) with a 3/8” x 2” Bolt (50) and a 3/8”
Nylon Locknut (42). Be sure that the Cable
Trap is turned to hold the Cable in place.
32
CABLE ASSEMBLY
31
50
94—Small tabs
should be down
42
82
88
38
82
88
88
66
12
82
88
98
4
83
43
38
43
4
94
94
76
29
30
31
88
37
84
44
88
50
13
82
80
42
50
88
82
80
42
13
44
37
84
88
Small Tabs
should be up