User`s manual

19
48. Wrap the Low Cable (86) around a 3 1/2”
Pulley (82). Attach the Pulley, a set of Pulley
Covers (94), and a 3/8” Washer (38) to the
Ab Upright (1) with the 3/8” x 3 3/4” Bolt (76)
and a 3/8” Nylon Jam Nut (43). Be sure that
the Cable Trap is in the indicated position.
49. Wrap the Low Cable (86) around a 3 1/2”
Pulley (82). Attach the Pulley and a set of
Pulley Covers (94) to the lowest holes in the
Pulley Plates (31) with a 3/8” x 2” Bolt (50)
and a 3/8” Nylon Locknut (42).
50. Wrap the Low Cable (86) around a 3 1/2”
Pulley (82). Attach the Pulley to the Ab
Upright (1) with the 3/8” x 3 1/2” Bolt (66), a
3/8” Washer (38), and a 3/8” Nylon Jam Nut
(43). The ball on the Cable must be on the
indicated side of the Pulley. Be sure that
the Cable and Pulley move smoothly and
that the Cable is between the Pulley and
the post.
51. Attach the Adjustment Tube (10) to the Leg
Press Arm (9) with the Lock Pin (73). Be sure
the Leg Press Plate (11) is oriented as
shown.
48
49
50
CABLE ASSEMBLY
10
15. Attach a Press Arm (7) to one side of the
Press Frame (12) with two 5/16” x 2 1/2” Bolts
(39) and two 5/16” Nylon Locknuts (40).
Attach the other Press Arm (7) to the Press
Frame (12) in the same manner.
16. Press a 1” Round Inner Cap (70) into one of
the Press Arms (7). Press a 1 3/4” Square
Inner Cap (48) into the Press Arm.
Repeat this step for the other Press Arm (not
shown).
17. Lubricate both axles on the Butterfly Frame (3).
Refer to the drawing to identify the Right
Butterfly Arm (5) and the Left Butterfly Arm (6).
Press a 1 3/4” Square Inner Cap (48) into the
upper end of the Left Butterfly Arm (6). Slide
the Left Fly Arm onto the indicated axle. Note:
Be careful not to confuse the Left Butterfly
Arm with the Right Butterfly Arm (5). Be
sure that the upper end of the Left Butterfly
Arm is behind the indicated bracket on the
Butterfly Frame (3).
IMPORTANT NOTE: Before assembling the
1” Retainers (45) used in this step, be sure
that you thoroughly understand the step.
The Retainers can be assembled only
once. If they must be removed, you will
need to order new Retainers.
Tap two 1” Retainers (45) and a 1” Round
Outer Cap (46) onto the axle. Be sure that
the teeth on the Retainers bend toward the
Round Outer Cap, as shown in the inset
drawing.
Attach the Right Butterfly Arm (5) in the same
way.
15
16
17
ARM ASSEMBLY
39
7
70
40
48
12
7
7
3
Lubricate Axle
Axle
6
5
45
48
46
Bracket
45
46
43
38
50
42
82
31
94—Small Tabs
should be down
94
94
82
86
76
1
43
38
82
66
Post
86
1
86
10
11
9
73
Hook
SEAT ASSEMBLY
51