User's Manual

ATTACHING THE SEAT FRAME

To attach the Seat Frame (36) to the Front Upright

(42), slide one of the three slots in the bracket on the

Seat Frame onto the pin on the Front Upright. Note:

The Seat Frame can be adjusted to three heights

using the different slots in the bracket. Secure the

Seat Frame to the Upright with the M10 x 80mm

Carriage Bolt (11) and the Seat Knob (49).

For some exercises, the Seat Frame (36) must be

removed. First, be sure that the chain is not attached

to the leg lever. Next, remove the Seat Knob (49) and

the M10 x 80mm Carriage Bolt (11) from the Seat

Frame. Lift the Seat Frame off the Front Upright (42).

Slot

ATTACHING THE CURL PAD

To attach the Curl Pad (24) to the weight system, the

seat frame must be attached to the front upright (see

ATTACHING THE SEAT FRAME above). Remove the

38mm Square Inner Cap (32) from the Seat Frame

(36). Insert the Curl Post (35) into the Seat Frame and

secure it with the Curl Knob (51).

Always remove the Curl Pad (24) when it is not in use,

and replace the 38mm Square Inner Cap (32).

ATTACHING THE LEG LEVER TO THE LOW

CABLE

To use the Leg Lever (29), the seat frame must be

attached to the front upright (see ATTACHING THE

SEAT FRAME above).

Attach one end of the Chain (52) to the end of the

Low Cable (69) by the Front Upright (42) with a Cable

Clip (53). Attach the other end of the Chain to the

bracket on the back of the Leg Lever (29) with anoth-

er Cable Clip.