User's Manual

15
33. Make sure that all parts have been properly tightened. The use of the remaining parts will be explained in
ADJUSTMENTS, beginning on the following page.
Before using the weight system, pull each cable a few times to be sure that the cables move smoothly over
the pulleys. If one of the cables does not move smoothly, find and correct the problem. IMPORTANT: If the
cables are not properly installed, they may be damaged when heavy weight is used. See the CABLE
DIAGRAMS on page 20 for proper cable routing. If there is any slack in the cables, you will need to
remove it by tightening the cables; see TROUBLESHOOTING AND MAINTENANCE on page 19.
32. Attach the Curl Pad (24) to the Curl Post (35) with
two M6 x 16mm Screws (18).
32
24
35
18
31. Attach the Seat Frame (36) to the Front Upright
(42) with the M10 x 80mm Carriage Bolt (11) and
the Seat Knob (49).
31
49
42
36
11