User's Manual

13
25. Wrap the Low Cable (69) around a 90mm Pulley
(15). Attach the Pulley, a pair of Pulley Covers
(40), and the Large Spacer (79) to the centre hole
in the Front Upright (42) with an M10 x 120mm
Bolt (85), an M10 Washer (9), and an M10 Nylon
Locknut (21). Be sure the large tabs on the
Pulley Covers are on the side shown.
25
Large
Tab
42
21
79
40
15
69
40
85
9
24. Wrap the Low Cable (69) around a 90mm Pulley
(15). Attach the Pulley and a pair of Pulley
Covers (40) to the Press Frame (17) with the M10
x 135mm Bolt (75) used in step 22, and an M10
Nylon Locknut (21). Be sure the large tabs on
the Pulley Covers are on the side shown.
24
Large
Tab
40
69
40
15
21
17
75
26. Attach the Shroud (59) to the bracket on the Top
Frame (55) with two M6 Washers (78) and two
M6 x 16mm Screws (18). Attach the Shroud to
the bracket on the Base (4) with two additional
M6 Washers and two M6 x 16mm Screws.
26
18
55
18
59
78
78
4
18
78
18
78
Seat Assembly