User's Manual

12
20. Wrap the Low Cable (69) around a 90mm Pulley
(15). Attach the Pulley and a pair of Pulley
Covers (40) to the second set of holes from the
bottom of the two Pulley Plates (58) with an M10
x 52mm Bolt (12) and an M10 Nylon Locknut
(21). Be sure the small tabs on the Pulley
Covers are on bottom.
20
12
40
69
Small
Tab
15
21
58
40
21. Wrap the Low Cable (69) around a 90mm Pulley
(15). Attach the Pulley and a pair of Pulley
Covers (40) to the upper hole in the Front Upright
(42) with an M10 x 115mm Bolt (87), an M10
Washer (9), an M10 Thick Spacer (81), and an
M10 Nylon Locknut (21). Be sure the large tabs
on the Pulley Covers are on the side shown.
23. Wrap the Low Cable (69) around a “V”-Pulley (6).
Attach the Pulley and a Long Cable Trap (50) to
the second hole from the end of the tube on the
Front Upright (42) with an M10 x 80mm Bolt (8),
two M10 Washers (9), and an M10 Nylon Locknut
(21).
22. Wrap the Low Cable (69) around a 90mm Pulley
(15). Attach the Pulley and a pair of Pulley
Covers (40) to the Press Frame (17) with an M10
x 135mm Bolt (75) and an M10 Thick Spacer
(81). Be sure the small tabs on the Pulley
Covers are on the side shown.
21
22
23
Large
Tab
15
69
87
40
81
9
40
21
42
75
40
40
17
81
15
69
42
50
6
9
8
21
9
69
Small
Tab