User's Manual

8
2. Orient the two Weight Guides (21) so that the
indicated holes are closer to the lower ends.
Attach the two Weight Guides and the Base (1)
to the Stabilizer (2) with two M10 x 80mm
10.9G Bolts (79), two M10 Washers (57), and
two M10 Locknuts (56). Tighten the Locknuts.
Attach the Upright (3) to the Base (1) with the
two indicated M8 x 75mm Carriage Bolts (78)
and two M8 Locknuts (58). Do not tighten the
Locknuts yet.
1
.
Insert four M8 x 75mm Carriage Bolts (78) up
through the Base (1). Note: It may be helpful
to place tape over the bolt heads to hold
them in place.
Frame Assembly
1
1
78
78
2
78
56
58
3
1
58
79
79
2
57
57
21
Holes
21
IMPORTANT: To make assembly easier,
read the assembly tips on page 7.