User's Manual

14
15. Orient a Press Arm Handle (17) with the 90° bend
at the top as shown in the inset drawing. Attach a
Press Arm Handle (17) to the Right Press Arm
(
16) with two M10 x 65mm Button Bolts (106),
four M10 Washers (80), four 11mm Spacers (99),
a
nd two M10 Nylon Locknuts (77).
Repeat this step for the Left Press Arm (not
shown).
16. Attach the Left Press Arm (15) to the Right Press
Arm (16) with an M10 x 110mm Bolt (93), an
90mm Spacer (59) and an M10 nylon Locknut
(77).
Finish attaching the Press Arms with two M10 x
65mm Bolts (85), two M10 Washers (80), and two
M10 Nylon Locknuts (77). Do not tighten the
Nylon Locknuts yet.
17. Apply grease to an M10 x 110mm Bolt (93).
Attach the Left and Right Press Arms (15, 16) to
the Base (1) with the Bolt, an 90mm Spacer (59),
and an M10 Nylon Locknut (77). Do not over-
tighten the Nylon Locknut; the Press Arms
(15, 16) must be able to pivot freely.
Tighten the Nylon Locknuts (77) used in
step 16.
16
16
15
77
77
59
93
80
85
17
16
15
77
1
106
16
9
9
99
99
80
80
77
99
80
80
17
1
5
90° Bend
90°
Bend
Grease
59
93