User's Manual

6
ASSEMBLY
1. Orient the Short Base (6) and the Long Base
(1) as shown.
Attach the Short Base (6) to the Long Base (1)
with two M10 x 103mm Bolts (57), four M10
Curved Washers (20), and two M10 Locknuts
(68).
1
1
6
68
20
20
20
20
57
57
To make assembly easier, carefully read the
following information and instructions:
• Assembly requires two persons.
• Because of its weight and size, assemble the
weight system in the location where it will be
used. Make sure that there is enough clearance to
walk around the weight system.
• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until assembly is completed.
• For help identifying small parts, use the PART
IDENTIFICATION CHART on pages 5 and 6.
• The following tools (not included) may be required
for assembly:
two adjustable wrenches
one rubber mallet
one standard screwdriver
one Phillips screwdriver
Assembly may be more convenient if you have a
socket set, a set of open-end or closed-end
wrenches, or a set of ratchet wrenches.
M10 Curved Washer (20)
S
mall M8
Washer (74)
M
6 Washer (79)
M
10 Washer (73)
5/8" Washer (71)
1/2" Washer (72)
13mm Washer (78)
2
26mm Washer (77)
Large M8 Washer (98)