User's Manual

22
42. Attach the lower Shroud Brackets (30) to the
Short Base (6) and to the Long Base (1) with
four M8 x 20mm Screws (65) and four Large
M8 Washers (98).
42
30
65
65
65
98
1
98
6
98
43. Attach the Curl Pad (86) to the Curl Post (87)
with two M8 x 16mm Screws (63) and two
Small M8 Washers (74).
44. Make sure that all parts are properly tightened.
The use of the remaining parts will be explained
in ADJUSTMENT, beginning on page 23.
IMPORTANT: If the cables are not properly
installed, they may be damaged when heavy
weight is used. Pull each cable a few times
to make sure that the cable moves smoothly
around the pulleys. If a cable does not move
smoothly, see the CABLE DIAGRAM on page
27, and find and correct the problem. If there
is any slack in the cables, see MAINTE-
NANCE on page 26.
43
86
87
74
63
74
63
41. Insert the hook on the J-bolt (80) into the center
hole in the Shroud Plate (82).
N
ext, insert the J-bolt (80) upward through the
Top Frame (8). Tighten the Wingnut (81) and
t
he M6 Washer (79) onto the end of the J-bolt.
Then, attach each upper Shroud Bracket (30) to
the Top Frame (8) with an M8 x 20mm Screw
(65) and a Large M8 Washer (98).
4
1
8
30
30
82
80
79
81
6
5
6
5
98
98
30