User's Manual

19
34. Route the Low Cable (54) over a Pulley (42).
Attach the Pulley (42) and two Cable Guides
(52) to the Double U-bracket (24) with an M10 x
50mm Bolt (58), two M10 Washers (73), and an
M10 Locknut (68).
Make sure that the Cable Guides (52) are
holding the Low Cable (54) in the groove of
the Pulley (42).
52
54
24
73
68
42
73
58
52
34
35. Attach the Low Cable (54) to the front eyelet on
the Long Base (1) with a Cable Clip (47).
35
1
54
47
33. Route the Low Cable (54) under a Pulley (42).
Attach the Pulley (42) and two Cable Guides
(
52) to the front bracket on the Long Base (1)
with an M10 x 50mm Bolt (58), two M10
W
ashers (73), and an M10 Locknut (68).
Make sure that the Cable Guides (52) are
holding the Low Cable (54) in the groove of
the Pulley (42).
33
1
58
73
73
4
2
54
6
8
52
5
2