User's Manual

17
2
7. Route the Ab Cable (93) under a Pulley (42).
Attach the Pulley (42) and two Cable Guides
(52) to the rear bracket on the Long Base (1)
w
ith an M10 x 50mm Bolt (58), two M10
Washers (73), and an M10 Locknut (68).
Make sure that the Cable Guides (52) are
holding the Ab Cable (93) in the groove of
the Pulley (42).
27
28. Route the Ab Cable (93) over a Pulley (42).
Attach the Pulley (42) and two Cable Guides
(52) between the indicated holes in the two
Pulley Plates (23) with an M10 x 50mm Bolt
(58), two M10 Washers (73), and an M10
Locknut (68).
Make sure that the Cable Guides (52) are
holding the Ab Cable (93) in the groove of
the Pulley (42).
28
29. Attach the Ab Cable (93) to the rear eyelet on
the Long Base (1) with a Cable Clip (47).
29
42
93
58
1
1
58
73
73
42
52
52
68
93
52
73
23
52
93
47
73
68