User's Manual

16
2
4. Locate the High Cable (53) hanging between the
center and rear brackets on the Top Frame (8).
Hold a Pulley (42) on the High Cable (53).
Attach the Pulley (42) and two Cable Guides
(
52) between the highest holes in the two Pulley
Plates (23) with an M10 x 50mm Bolt (58), two
M10 Washers (73), and an M10 Locknut (68).
Make sure that the Cable Guides (52) are
holding the High Cable (53) in the groove of
the Pulley (42).
24
25. See the CABLE DIAGRAM on page 27 and
identify the Ab Cable (93).
Route the Ab Cable (93) through the Upright (5)
as shown.
Next, route the Ab Cable (93) over a Pulley
(42). Attach the Pulley and two Pulley Covers
(36) inside the Upright (5) with an M10 x 85mm
Bolt (95), two M10 Washers (73), two 22mm
Spacers (97), and an M10 Locknut (68).
Make sure that the Pulley Covers (36) are
holding the Ab Cable (93) in the groove of
the Pulley (42).
25
26. Route the Ab Cable (93) over a Pulley (42).
Attach the Pulley (42) and two Cable Guides
(52) to the Offset Double U-bracket (85) with an
M10 x 50mm Bolt (58), two M10 Washers (73),
and an M10 Locknut (68).
Make sure that the Cable Guides (52) are
holding the Ab Cable (93) in the groove of
the Pulley (42).
Then, pull the Ab Cable (93) downward in the
indicated location so that there is slack in the
Ab Cable. The slack will be used in step 30.
26
8
5
3
52
52
5
95
36
42
73
73
73
93
68
7
3
68
23
58
52
93
85
73
68
23
36
42
97
97
73
58
42
Pull
52