User's Manual

14
1
8. Route the Arm Cable (51) over a Pulley (42).
Attach the Pulley (42) and two Cable Guides
(52) to the left U-bracket (22) on the Upright (5)
w
ith an M10 x 50mm Bolt (58), two M10
Washers (73), and an M10 Locknut (68).
Make sure that the Cable Guides (52) are
holding the Arm Cable (51) in the groove of
the Pulley (42).
18
19. Apply grease to an M10 x 32mm Bolt (59).
Attach the end of the Arm Cable (51) to the Left
Arm (12) with the M10 x 32mm Bolt (59), an
M10 Washer (73), and an M10 Locknut (68). Do
not overtighten the Locknut; the end of the
Arm Cable must pivot easily.
19
20. See the CABLE DIAGRAM on page 27 and
identify the High Cable (53).
Route the High Cable (53) over a Pulley (42).
Attach the Pulley (42) and two Pulley Covers
(36) to the front bracket on the Top Frame (8)
with an M10 x 50mm Bolt (58), two M10
Washers (73), and an M10 Locknut (68).
Make sure that the Pulley Covers (36) are
holding the High Cable (53) in the groove of
the Pulley (42).
Then, route the High Cable (53) through the
Arm Frame (9) and through the Upright (5) as
shown.
20
58
42
51
51
12
52
52
22
68
68
36
36
53
42
73
73
58
8
9
5
73
Grease
73
68
73
5
59