User's Manual

6. Insert two Weight Guides (5) into the Base (1).
Make sure that the holes are on the top.
Slide two Weight Bumpers (44) onto the Weight
G
uides (5). Slide the nine Weights (16) onto the
Weight Guides.
Press the Weight Tube Bumper (17) into the
Weight Tube (18). Insert the Weight Tube into the
stack of Weights (16) as shown.
Lubricate the indicated holes in the Top Weight
(19) with grease. Slide the Top Weight onto the
Weight Guides (5).
Make sure the pin on the
Weight Tube (18) rests in the pin grooves on
the bottom of the Top Weight.
7. Press two 50mm Square Inner Caps (31) into the
Top Frame (6).
Attach the Top Frame (6) to the Front and Rear
Uprights (4, 3) with four M10 x 68mm Bolts (87),
four M10 Washers (71), and four M10 nylon
Locknuts (72).
Do not tighten the Locknuts yet.
Attach the Weight Guides (5) to the Top Frame
(6) with an M10 x 153mm Bolt (91), two M10
Washers (71), two 18mm Spacers (101), and an
M10 Nylon Locknut (72).
Do not tighten the
Locknuts yet.
Tighten the Nylon Locknuts (72, 73) used in
steps 2–7.
7
6
5
1
9
Pin
Pin
Groove
Lubricate
Holes
18
17
16
44
1
31
4
3
5
71
71
91
72
72
72
72
72
101
101
87
71
87
71
31
6
8
8. Wet the Step Handle (12) with soapy water. Slide
two Grips (41) onto the Step Handle.
Attach the Step Handle (12) to the Rear Upright
(3) with two M8 x 65mm Bolts (102), two M8
Washers (103), and two M8 Nylon Locknuts (73).
8
12
102
103
73
3
41
41
Arm Assembly