User's Manual

TROUBLESHOOTING

Make sure all parts are properly tightened each time the weight system is used. Replace any worn parts immedi-

ately. The weight system can be cleaned using a damp cloth and mild non-abrasive detergent. Do not use solvents.

TIGHTENING THE CABLES

Woven cable, the type of cable used on the weight system, can stretch slightly when it is first used. If there is

slack in the cables before resistance is felt, the cables should be tightened. Slack can be removed from the

cables in several different ways.

TIGHTENING THE PULLEY PLATES

Slack can be removed by moving a 90mm Pulley (not

shown) and the two Pulley Covers (49) to a set of

holes closer to the centre of the two Pulley Plates

(50). Remove the M10 Nylon Locknut (72) and the

M10 x 53mm Bolt (88) from the Pulley Covers, the

Pulley, and the Pulley Plates. Re-attach the Pulley

and the Pulley Covers to the new set of holes in the

Pulley Plates with the Bolt and Locknut.

TIGHTENING THE “U”-BRACKET

Slack can be removed by moving the 90mm Pulley

(not shown) and the two Pulley Covers (49) to the

upper set of holes in the “U”-bracket (53). Remove

the M10 Nylon Locknut (72) and the M10 x 53mm

Bolt (88) from the Pulley Covers, the Pulley, and the

“U”-bracket. Re-attach the Pulley and the Pulley

Covers to the new set of holes in the “U”-bracket with

the Bolt and Locknut.

Slack can also be removed from the Short Cable (94)

by tightening the M8 Nylon Locknut (73) two turns

onto the Short Cable.