User's Manual

34. Set the Seat Frame (7) on the pin on the Front

Upright (4). Secure the Seat Frame with an M8 x

7mm Carriage Bolt (82) and the M8 Knob (43).

35. Make sure that all parts are properly tightened. The use of all remaining parts will be explained in ADJUST-

MENT, beginning on the following page. Before using the weight system, pull each cable a few times to

make sure that the cables move smoothly over the pulleys. If one of the cables does not move smoothly,

locate and correct the problem before using the weight system.

IMPORTANT: If the cables are not proper-

ly routed, they may be damaged when heavy weight is used. See the CABLE DIAGRAM on page 20

of this manual.