User's Manual

17
2
7. Route the Low Cable (54) over a Pulley (42).
Attach the Pulley (42) and two Cable Guides
(52) to the Double U-bracket (24) with an M10 x
5
0mm Bolt (58), two M10 Washers (73), and an
M10 Locknut (68).
Make sure that the Cable Guides (52) are
holding the Low Cable (54) in the groove of
the Pulley (42).
27
28. Route the Low Cable (54) under a Pulley (42).
Attach the Pulley (42) and two Cable Guides
(52) to the rear bracket on the Long Base (1)
with an M10 x 50mm Bolt (58), two M10
Washers (73), and an M10 Locknut (68).
Make sure that the Cable Guides (52) are
holding the Low Cable (54) in the groove of
the Pulley (42).
28
29. Route the Low Cable (54) over a Pulley (42).
Attach the Pulley (42) and two Cable Guides
(52) between the second from the bottom set of
holes in the two Pulley Plates (23) with an M10
x 50mm Bolt (58), two M10 Washers (73), and
an M10 Locknut (68).
Make sure that the Cable Guides (52) are
holding the Low Cable (54) in the groove of
the Pulley (42).
Attach the end of the Low Cable (54) to the
Long Base (1) with a Cable Clip (47).
29
5
8
73
24
73
68
52
52
42
54
54
54
47
1
42
42
23
52
52
58
58
73
73
73
73
68
68
1
52
52