User's Manual

16
2
4. Locate the High Cable (53) hanging between
the center and rear brackets on the Top Frame
(8).
S
et a Pulley (42) on the High Cable (53).
A
ttach the Pulley (42) and two Cable Guides
(52) between the top holes in the two Pulley
Plates (23) with an M10 x 50mm Bolt (58), two
M10 Washers (73), and an M10 Locknut (68).
Make sure that the Cable Guides (52) are
holding the High Cable (53) in the groove of
the Pulley (42).
24
25. See the CABLE DIAGRAM on page 26 and
identify the Low Cable (54).
Attach the end of the Low Cable (54) to the Leg
Lever (3) with a Cable Clip (47).
Route the Low Cable (54) through the front
bracket on the Long Base (1) and through the
hole in the Upright (5).
Attach a Pulley (42) and two Cable Guides (52)
to the front bracket on the Long Base (1) with
an M10 x 50mm Bolt (58), two M10 Washers
(73), and an M10 Locknut (68).
Make sure that the Cable Guides (52) are
holding the Low Cable (54) in the groove of
the Pulley (42).
25
26. Route the Low Cable (54) through the center
bracket on the Long Base (1).
Attach a Pulley (42) and two Cable Guides (52)
to the center bracket on the Long Base (1) with
an M10 x 50mm Bolt (58), two M10 Washers
(73), and an M10 Locknut (68).
Make sure that the Cable Guides (52) are
holding the Low Cable (54) in the groove of
the Pulley (42).
26
8
53
52
52
52
47
54
3
5
1
1
58
52
42
42
73
73
58
73
73
68
73
68
42
54
73
68
23
58
23
52
52